Lubrication And Maintenance Chart - Scag Power Equipment SW Operator's Manual

BREAK-IN
8 HOURS (DAILY)
40 HOURS (WEEKLY)
100 HOURS (BIWEEKLY)
500 HRS OR ANNUALLY
X
Check all hardware for proper tightness
X
Change engine oil and filter at 5 hours
X Check engine oil
X Remove debris from under belt cover
X Sharpen cutter blades
X Grease spindle bearings
X Clean air filter
X Check belt tension
X Check tire pressure
X Change engine oil
X Replace air filter
X Grease caster wheel bearings
X Grease caster wheel pivot shafts
X Grease idler pulley bracket on cutter deck
X Grease drive wheel bearings
X Grease transmission couplers
X Grease idler bracket LH & RH
X Check all hardware for proper tightness
X Adjust air gap on electric clutch
LUBRICATION & MAINTENANCE
+ Grease spindle until grease comes out the relief valve.
Compatible Greases:
PROCEDURE
Lidok EP #2 (found at industrial shops)
Ronex MP (Exxon service stations)
Shell Alvania (Shell service stations)
Mobilux #2 (Mobil service stations)
Super Lub M EP #2 (Conoco service stations)
Do not over fill
More often if needed
More often if needed
+ US Lithium MP White Grease 2125
More often if needed
Add or adjust as required
See engine mfg. information
More often if needed
Chassis grease
Chassis grease
Chassis grease
Chassis grease
Chassis grease
Chassis grease
More often if needed
Contact your Scag dealer for information about
making this adjustment
14
COMMENTS