Unit 5: Printer Configuration
CRC (CYCLIC REDUNDANCY CHECK) MODE
Allows the operator to enable or disable the Cyclic Redundancy Check (CRC) for each received
print data when using wireless LAN or Bluetooth interface.
Refer to Figure 1-1 of the Introduction unit in this manual for dipswitch location.
SATO MB2i Service Manual
Choose Applicable Option
Enable CRC Check: (DSW = 1: OFF, 2: ON, 3: ON, 4: ON) + Cover Open + PRINT + POWER
Disable CRC Check: (DSW = 1: OFF, 2: ON, 3: ON, 4: ON) + Cover Open + FEED + POWER
Flashes green when saving
the Head Check setting.
Flashes green when setting
Figure 5-7, CRC Check Mode
PN 9001145B
completed.
Confirm setting is
complete.
Press POWER.
Printer shuts down.
Page 5-12