Error Indicators - SATO MB 200i Operator's Manual

ERROR INDICATORS

STATUS LED MODE
Light (red) All modes
Blink (red) Online
every 2s
Light (red) After Power On
Blink (green- Online
red) every 2s
Blink (red) Online
every 0.5s
Blink (green) at Online
0.5s intervals (Printing or
receiving data)
Blink (green) All modes
every 4s
MB200i Operator Manual
Table 7-2, Error Indicators
DESCRIPTION CAUSE
Low battery Battery charge
level is low
Error in Interface module
Bluetooth or error (Bluetooth,
WLAN card wireless LAN)
1. Program Flash ROM
illegal error read/write error
2. Flash ROM- has occurred
error
Head error Head wiring is
disconnected
Cover open 1. Cover is not
Paper End locked
Sensor error 2. Cover open/
close sensor
malfunctioning
3. Paper is not
present
4. Wrong sensor
level
5. Wrong sensor
type
6. Paper skew
Buffer near full Insufficient
space in
Receive Buffer
area
Sleep mode Not in error. Low
power
consumption
mode is active.
-
Unit 7: Troubleshooting
REMEDY
Recharge the
battery
Contact a SATO
service center
1. Replace Flash
ROM*
2. Retry
downloading
program*
Replace the head*
1. Lock the cover
2. Adjust sensor
level*
3. Load paper
4. Adjust sensor
level*
5. Set correct
sensor type
6. Reload paper
Stop sending data
from the host, and
wait until the buffer
becomes empty.
Resume sending
data.
Clear the mode by
receiving data,
pressing a button,
opening or closing
the cover.