Table of Contents
Advertisement
Section 9. Optional Accessories
Label Cutter Kit Installation
CUTTER UNIT
Fig. 9-4
REMOVE (2)
SCREWS AND
DETACH EXISTING CABLE FROM
DISCARD BRACKET
THE CUTTER PCB AT "CUTP"
AND "CUTS".
INSTALL NEW CABLE AT SAME
LOCATIONS
Fig. 9-3
ROUTE CABLE CONNECTORS FROM
THE CUTTER THROUGH ACCESS
HOLE IN PRINT ENGINE ASSEMBLY
AND THROUGH THE HOLE IN THE
ALUMINUM SIDE PLATE
Figs. 9-5
Page 9-4
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
Advertisement
Table of Contents
Troubleshooting
