Joining Drill Chuck & Arbor - Grizzly G7944 Owner's Manual

25. Insert table shaft into table support assembly.
26. Tighten small locking lever to secure table
in table support assembly. The table should
now be installed, as shown in Figure 23.
Figure 23. Table installed (G7943 shown).
27. Remove dust plug from light socket.
28. Install a 60W or smaller light bulb in location
shown in Figure 24.
Light Bulb
Access Here
Figure 24. Light bulb access location.
Use only bulbs that are "safety coated" and
shatter resistant. The bulb will be exposed
at the bottom of the head casting which
helps with illumination. Impacts with a bulb
not "safety coated" may shatter, expos-
ing the electrical filaments and creating an
electrical shock hazard.
-24-
Joining Drill Chuck
& Arbor
An arbor is included for the drill chuck that
comes with this machine. The following procedure
describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. If you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
Important: DO NOT install the drill chuck
and arbor assembly into the spindle until AFTER
the test run.
To join drill chuck and arbor:
1. Use acetone or lacquer thinner to clean drill
chuck and arbor mating surfaces, especially
the bore.
2.
Retract chuck jaws completely into chuck.
3.
Insert small end of arbor into chuck.
4. Hold assembly by the arbor and tap chuck
onto a block of wood with medium force, as
illustrated below.
Figure 25. Tapping drill chuck/arbor on block of
wood.
5.
Attempt to separate drill chuck and arbor by
hand —if they separate, repeat Steps 3–4.
Model G7943/G7944 (Mfd. Since 09/17)