Section 4: Operations; Operation Overview - Grizzly G7944 Owner's Manual

SECTION 4: OPERATIONS

To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-26-
manual BEFORE

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1. Examines workpiece to make sure it is suit-
able for drilling.
2. Puts on required safety glasses and face
shield.
3. Firmly secures workpiece to table using a
vise or T-slot clamps.
4.
Installs correct cutting tool for operation.
5.
Adjusts table to correct height, then locks it in
place.
6.
Selects appropriate spindle speed according
to V-belt configuration chart located inside
belt cover.
7. Connects machine to power, and turns
machine ON.
8.
Begins drilling.
9. When finished, turns machine OFF and dis-
connects it from power.
Model G7943/G7944 (Mfd. Since 09/17)