Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Nemtek WIZORD
Summary of Contents for Nemtek WIZORD
- Page 1 WIZORD Electric Fence Energizer User Manual...
-
Page 2: Table Of Contents
Table of Contents Introduction Company Profile Guarantee Nemtek group outlets Standard Operating Procedures Standard Operating Procedures - Notes Standard Operating Procedures - LEDs Features & Functions IEC Safety Information Document revision history... -
Page 3: Introduction
The guidelines provided in this manual will assist you with the basic operation and maintenance of your WIZORD. The WIZORD is designed and manufactured in South Africa for the South African and international markets. More information on our products and general information is available on our web site at: http://www.nemtek.com. -
Page 4: Guarantee
Faulty units must be returned to one of the Nemtek Group outlets. The buyer shall pay all shipping and other charges for the return of the product to Nemtek or Nemtek Security Warehouse. -
Page 5: Nemtek Group Outlets
NEMTEK Group Outlets HEAD OFFICE Tel: +27 (0)11 462 8283 Northriding Commercial Park Fax: +27 (0)11 462 7132 Stand 251, Aintree Street, Northriding Randburg, South Africa EXPORTS Tel: +27 (0)11 462 8283 exports@nemtek.com Fax: +27 (0)11 462 7132 EDENVALE Tel: +27 (0)11 453 1970... -
Page 6: Standard Operating Procedures
RESETTING THE ALARM: Switch the unit off with the Nemtek tab or remote key-switch. This will silence the siren (if it has not already timed-out), internal buzzer and will switch the strobe off. -
Page 7: Standard Operating Procedures - Notes
Standard Operating Procedure BUZZER: The buzzer has a different cadence for the fence alarm and gate alarm. SERVICE INDICATION: The service indicator should remain off during normal operation. If it is lit due to an obvious condition, such as prolonged mains failure, simply turn the unit off and on again. -
Page 8: Standard Operating Procedures - Leds
Standard Operating Procedure - LEDs The status of the energizer and the fence is displayed on the front panel of the energizer, as follows: Under normal operating conditions: Mains present, battery charging Fence energized No fence alarm No gate alarm No service condition If all are flashing, fence is operating correctly... -
Page 9: Features & Functions
The energizer can be wired to a remote on/off switch. There is only one external input and the selection of gate, remote on/off or low/high voltage is exclusive. GATE INPUT: Gate delay entry of four minutes, one minute (Wizord 2 only) or immediate entry alarm. HIGH/LOW VOLTAGE: The energizer (Wizord 2 only) can be switched between low/high voltage mode. -
Page 10: Iec Safety Information
Electric fencing can be lethal. Avoid head contact with the fence. Ask the installer to explain the options of current limiting resistors. Rev 1.5, 4 February 2016 Updated for Wizord 4i Rev 1.6, 20 June 2016 Combined Wizord 4i and Wizord 2 Print Code: MO 025...