Adjusting The Size Of Cubes; Turning Off The Refrigerator, And When Not In Use - Dometic DM2652 Operating Instructions Manual

INSTRUCTIONS FOR USE
To prevent water from splashing out of the mold as-
sembly while travelling in your RV, raise the bail arm
to the full UP/OFF position about 1-1/2 hours before
departing. This will allow the water in the mold to
freeze.
WATER SUPPLY
The water supply system must have a minimum
pressure of 15 pounds per square inch gauge
(psig). A 1/4" diameter water line to the water valve
should be used at the rear of the refrigerator. The
water line must have a manual shutoff valve placed
where it is easily accessible.
The maximum water level is represented by a thin
line. It is essential that the water level does not ex-
ceed this line! See (FIG. 6).
FIG. 6
Maximum
water level
If necessary, change the water flow by adjusting
the water supply. For instructions, see "E. Adjusting
The Size Of Cubes".
E.

Adjusting The Size Of Cubes

 I f the ice maker was cleaned and drained, no
ice cubes will be dumped into the bin during
the first cycle.
The first few cycles may have small cubes due to
air trapped in the water lines. The first container of
ice cubes should be dumped if the water system
has been winterized or not used for several weeks.
Once the ice maker has run through several cycles,
and if cubes are too small or sticking together, ad-
justment is necessary on the amount of water en-
tering the mold.
TO ADJUST THE SIZE OF CUBES, FOLLOW
THESE STEPS:
1.  R emove the protective cover from the ice maker
mechanism. Using a flat-bladed screwdriver,
place the tip of the screwdriver in the slot. Twist
the screwdriver blade gently to loosen the cover.
See (FIG. 7).
FIG. 7
2. Locate the adjusting screw under the protective
cover. Turn the screw counterclockwise to in-
crease the size of cubes. See (FIG. 8).
FIG. 8
3. Turn the screw clockwise to decrease the cube
size or if the mold is overfilling, and the cubes
are stuck together. See (FIG. 8).
 T o prevent overfilling, do NOT turn the ad-
justment screw more than one revolution at
a time. Allow the ice maker to cycle several
times before another adjustment is made. Be
sure to replace the protective cover on the
cycle after the adjustments are complete.
F. Turning Off The Refrigerator, And When
Not In Use
You can turn off your refrigerator by pressing the
main power ON/OFF button found on the control
panel to the OFF position. This will shut off all power
to the refrigerator, including DC power to the refrig-
erator. See (FIG. 1), (FIG. 2) and (FIG. 3).
9
Adjusting screw
Cover