Ice Cubes; Product Care; Defrosting; Airing Position - Dometic DM2652 Operating Instructions Manual

STORAGE COMPARTMENTS
FIG. 10
3. Reposition the shelf in the desired location. In-
sert the ends of the wire shelf on the left-hand
side and slide the shelf into the holes on the
right-hand side. See (FIG. 10).
4. Slide the plastic plugs into the holes of the wall.
5. Snap the shelf locks back onto the wire shelf.
See (FIG. 11).

PRODUCT CARE

A.

Defrosting

1.  S hut off the refrigerator by pressing the main
power ON/OFF button (OFF position).
2. Empty the refrigerator.
3. Leave the cabinet and freezer doors open and
make sure the drip tray is in place under the
finned evaporator.
 D efrosting time can be reduced by filling ice
trays with hot water and placing them in the
freezer compartment.
 FIRE, BURN, OR INHALATION
HAZARD. Do NOT fracture or puncture cooling
unit. This could cause a leak in the cooling system.
See "General Safety Messages" for information on
cooling systems, and consequences of exposure to
refrigerant.
Do NOT use a knife, ice pick, or any other sharp
tool to remove frost from freezer compartment.
 Do NOT use a hot air blower to re-
move frost from storage compartment(s). Perma-
nent damage could occur, including warped metal
or plastic parts.
4. When all the frost has melted, dry the interior
with a clean cloth and turn the refrigerator back
on.
DM2662, DM2663 & DM2862:
5. Set the thermostat to the coldest setting for a
few hours. Then, reset the thermostat to the
desired setting, usually at mid setting. Replace
food after refrigerator has reached appropriate
cool temperature.
FIG. 11
D.

Ice Cubes

Ice cubes can be made in the freezer compartment.
For faster freezing, place trays in direct contact with
the bottom of the freezer compartment.
DM2662, DM2663 & DM2862:
Ice will be made more rapidly if the thermostat is set
at its highest position, but be sure to move the ther-
mostat back to normal setting when ice is formed;
the refrigerator might otherwise become too cold.
B.

Airing Position

DM2652, DM2662, DM2663, DM2852 & DM2862:
Use the airing position
card to keep the doors
ajar if the refrigerator is
put in storage or will not
be used for an extend-
ed period of time. See
(FIG. 13).
FIG. 13
3
11
FIG. 12
1
4 5
2