Table of Contents
Advertisement
2
PREPARATION
K!l
AuTO SETUP
r:rij—
POWER
r
—OK
If you want to recall the AUTO
SETUPscreen, simply press both
CHANNEL(+ and -) buttons on
the VCRfor 3 seconds or more.
e
CHANNEL (+, -)
If in your area, UHF channel 36
is used by a broadcaster, follow
the steps below.
1
2
3
r
I
I
5
Tune the TV receiver to an
available UHFchannel between
channel 32 and 41 (a UHF
channel not used by a TV
station),
Using a small screwdriver,
slowly turn the video channel
adjustment screw "RF
CHANNEL"on the back of the
VCR,to the right fora higher
channel than 36 and to the left
for a lower channel than 36.
Adjust the tuning on the TV, if
necessary, so that the
AUTO
SETUP
screen is clear.
RF CHANNEL
i
VCR PRESETTING
After all the connections
are completed,
please follow steps
-
to -
before using the VCR.
-
W"stiw theTv r-iver tothevideo
channel
_
Tuning
control
(AUTO)
_
Clock setting
Adiustina the TV receiver to the video
Tuning control (AUTO)
channel -
1
F'ress the POWER button.
z
Turn cmycmrTV.
For more details, please refer to your TV
receiver instruction manual.
Note:
If the VCR has been connected to the TV using the
'(AVconnection", simply set your TV receiver to the
'(AV mode and the AUTO SETUP screen will
appear on your TV screen. Go to step 5.
3
4
Auto
tuning
This VCR has a built-in tuner capable of
tuning up to 88 TV stations. Each TV station
broadcasting
channel is memorized by the
VCR as a programme
position number (01 –
88).
The TV stations available in your area will be
automatically
preset in order starting from
programme
position number "01".
Because of this you may have to sort the TV
stations into the correct order. Please refer to
"Sorting the TV stations".
In case of an "RF connection",
set your
When all available TV stations have been
TV receiver to "VCR" or the position
preset, the function will stop and the TV
designated for VCR use (usually a
station preset to programme
position number
position where no TV programme
is
"01" will be tuned on your TV screen.
received).
Notes:
For more details, please refer to your TV
receiver instruction manual.
Adjust the tuning on the TV to UHF
channel 36 so that the AUTO SETUP
screen is clear.
TV
screen
AUTO SETUP
[OKI +ENTER
[MENUI +TV
This is your video channel.
To view a tape playback or to watch a TV
broadcast tuned on the VCR tuner, set the TV
to the video channel.
b
When the AUTO SETUP screen is clear,
press the OK button.
Auto tuning
will start.
During the auto tuning operations, please do not
press any of the buttons or controls on the VCR
or remote control.
Auto tuning is not possible if the VCR is set to
AV input mode.
The skip function will be automatically set for all
position numbers where no TV station has been
preset.
Advertisement
Table of Contents
