Lamp Replacement - Sanyo PLC-WXU300K Owner's Manual

Maintenance and Cleaning

Lamp Replacement

When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
Note:
• When Mode 2 is selected in the Lamp life control menu,
if the projection lamp of the projector reaches its end of
life, the lamp replacement icon appears on the screen,
and the projector is turned off automatically after 3
minutes.
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.46), during "FREEZE
button" (p.25), or "NO SHOW button" (p.26).
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the Lamp Cover. The inside of
the projector can become very hot.
Follow these steps to replace the lamp.
Unplug the AC power cord. Let the projector cool for at
1
least 45 minutes.
Loosen the screw and open the lamp cover.

Loosen the three (3) screws that secure the lamp. Lift
3
the lamp out of the projector by using the handle.
Replace the lamp with a new one and secure the three
4
(3) screws. Make sure that the lamp is set properly.
Close the lamp cover and secure the screw.
Connect the AC power cord to the projector and turn
5
on the projector.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No . of your projector
●
Replacement Lamp Type No .
64
: PLC-WXU300, PLC-WXU300K
: POA-LMP131
(Service Parts No. 610 343 2069)
Top Control
Lamp replacement icon
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Lamp Cover
Screw
Lamp
Screw
Screw
LAMP REPLACE
indicator
Handles
Screw