Sanyo PLC-WXU300K Owner's Manual page 52

Setting
Standby mode
This function is available when operating the projector via
network.
Network .... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco . ........... Select Eco when you do not use the projector
via network. The projector's network function
will stop when turning off the projector.
Refer to the owner's manual of "Network Set-up and
Operation".
Note:
• Factory default is Eco.
• When selecting Network, the cooling fans may be running
depending on the temperature inside the projector even if
the projector is turned off.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready . ................. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the top control or remote control is
pressed.
Shut down .......... When the lamp has been fully cooled
down, the power will be turned off.
Off ....................... Power management function is off.
Timer . .................. If the input signal is interrupted and
no button is pressed for more than
30 seconds, the timer display with No
signal appears. It starts the countdown
until the lamp is turned off. Use the Point
▲▼
Note:
Factory default is Ready: 5 min.
5
buttons to set the Timer(1~30min).
Power management
Timer left before Lamp is off.