Table of Contents
Advertisement
Auto setup
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP button
on the top control or the AUTO SET button on the remote
control. Settings for those functions can be altered as follows:
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point
buttons to select one of the following options.
Off ........... Input search will not work.
On1.......... Input search works under the following situation.
– When pressing the AUTO SETUP button on
the top control.
– When pressing the AUTO SET button on the
remote control.
On.......... Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET button on the
remote control.
– When pressing the AUTO SETUP button on
the top control.
– When the current input signal is cut off.*
*
If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
Auto PC adj .
On. . . . . . . . Enables Auto PC adjustment when pressing
the AUTO SET button on the remote control or
the AUTO SETUP button on the top control.
Off. . . . . . . . Disables Auto PC adjustment.
Auto Keystone
Auto . . . . . Always works and corrects keystone distortion
according to the projector's tilt.
Manual . . . . Works only when pressing the AUTO SETUP
button on the top control or the AUTO SET
button on the remote control.
Off. . . . . . . . Disables Auto Keystone.
Note:
• While Input search is set to On1 or On, the status of
Input and Lamp are displayed every time the signal is
switched.
• During Input search is in progress, if the INPUT button
on the top control, the COMPUTER1/2, HDMI, S-
VIDEO, COMPONENT or the VIDEO button on the
remote control, the MENU button or the ON/STAND-BY
button is pressed, Input search will stop. If the INPUT
button is pressed, the Input search will go back to the
current search signal. If the COMPUTER 1/2, HDMI,
VIDEO, S-VIDEO or COMPONENT button is pressed,
Input search will go back to the button's input signal.
Auto setup
▲▼
Note:
• Input search, Auto PC adj . and Auto Keystone
cannot be set Off at the same time.
• Auto Keystone corrects vertical distortion only, not
correct horizontal distortion.
• The Auto Keystone function cannot work when the
Ceiling feature is set On in the Setting menu (p.50).
• Perfect correction of the image distortion cannot be
ensured with the Auto setup function. If the distortion is
not corrected properly by pressing the AUTO SETUP
or AUTO SET button, adjust manually by pressing the
KEYSTONE button on the remote control or selecting
Keystone in the Setting menu (pp.23, 46).
• Fine sync ., Total dots, Horizontal and Vertical
position of some computers cannot be fully adjusted
with the Auto PC adjustment function. When the image
is not provided properly with this operation, manual
adjustments are required (pp.31-32).
• Only the last selected input source can be
detected.
Setting
Picture in Picture
Picture in Picture
Standby mode
Network
45
Advertisement
Table of Contents
