Input Source Selection (Component, Rgb Scart 21-Pin, Hdmi) - Sanyo PLC-WXU300K Owner's Manual

Video Input
Input Source Selection (Component, RGB Scart 1-pin, HDMI)
Direct Operation
Choose Computer 1 by pressing the INPUT button on the top control or press the COMPUTER button on the
remote control; choose HDMI by pressing the INPUT button on the top control or press the HDMI button on the
remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
Top Control
INPUT button

COMPUTER  can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.
Menu Operation
Press the MENU button to display the On-Screen
1
Menu. Use the Point
then press the Point
Use the Point
▲▼

then press the Point
buttons to select HDMI, and then press the SELECT
button.
When Computer 1 is selected, use the Point
3
buttons to select Component or RGB(Scart) and then
press the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
When the video signal is connected to the
HDMI
HDMI terminal, select HDMI.
Note:
When the Input Search function is set to On1 or On,
the input signal will be searched automatically (p.45).
38
Computer 1

Computer 
HDMI
Video
S-video
buttons to select Input and
▲▼
or the SELECT button.
►
buttons to select Computer 1 and
button; use the Point
►
Remote Control
Input Menu
▲▼
▲▼
COMPUTER 1 button
Computer 1(RGB)
Computer 1(Scart)
COMPONENT button
Computer 1
(Component)