Advertisement
Assembly Instructions
SC POWER ASSEMBLY INSTRUCTIONS
STEP 1: Slide the threaded stabilizer plate into the bike frame
then use a 13mm socket to secure the rear stabilizer onto the
frame using two (2) pieces of the M8 x 30mm bolts and M8 wash-
ers. Repeat this step for the front stabilizer.
STEP 3: Slide the seat post into the frame by loosening the height
adjustment pop pin, then pulling outwards on the pin while
sliding the seat into the frame.
Threaded
Stabilizer
Plate
STEP 2: Insert one (1) piece of the trapezoidal fore/aft locking
nut into the handlebar post then slide the handlebars onto
the handlebar post. Secure one (1) piece of the threaded collar
locking nut through the handlebars and into the trapezoidal fore/
aft locking nut using a 10mm allen key. Next, slide one (1) piece
of the M8 washer onto the fore/aft adjustment knob then tighten
the fore/aft adjustment knob into the threaded collar locking nut.
STEP 4: Pull down on the seat slider locking pin then slide the
seat assembly onto the seat post installed in Step 3, tightening
the fore/aft adjustment knob to lock the seat slider into place.
Fore/Aft
Adjustment
Knob
M8 Washer
Threaded Collar
Locking Nut
Trapezoidal
Locking Nut
Page 5
620-8607 Rev. A
Advertisement
