Keystone Correction - Sanyo PJ LINK PLC-XU106K Owner's Manual

Keystone Correction

If a projected picture still has keystone distortion after
pressing the AUTO SETUP button on the top control or the
AUTO SET button on the remote control, correct the image
manually as follows:
Press the KEYSTONE button on the top control or on
the remote control to switch the Standard (for Vertical/
Horizontal) /Corner adjustment. The Standard or Corner
adjustment dialog box appears. Use the Point
buttons to correct the Standard or Corner distortion. The
Standard or Corner adjustment can be stored (see page
48).
Standard
Reduce the lower width
▼
with the Point button.
Reduce the right part
►
with Point button.
Corner
Press the KEYSTONE button on the top control or on the
remote control to switch Corner adjustment, press the
SELECT button on the remote control to select the corner
you want to adjust.
Reduce the top left corner part
►▼
with the Point buttons.
Press the SELECT
button
Keystone
Press the SELECT
button
Press the SELECT
button
Keystone
Reduce the bottom left corner
►▲
part with the Point buttons.
▲▼◄►
Reduce the upper width
▲
with the Point button.
Reduce the left part with
◄
Point button.
Reduce the top right corner part
◄▼
with the Point buttons.
Keystone
Press the SELECT
button
Keystone
Reduce the bottom right corner
◄▲
part with the Point buttons.
Top Control
AUTO SETUP button
KEySTONE button
POINT ▲▼◄►
buttons
Remote Control
Note:
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press and hold the KEYSTONE button for
more than 3 seconds while the Standard or Corner
dialog box is being displayed, the Standard or Corner
correction will be released.
• The Corner pattern can be set to Off, Red, white or
Blue in the Corner pattern function. See "Keystone"
on page 48.
• The adjustable range is limited depending on the
input signal.
• Standard and Corner functions cannot be adjusted at
the same time. If one of the fuctions is adjusted, and
then the other one will be reset automatically.
• The corner keystone function may be canceled when
you set the Auto keystone function to Auto or Manual.
To avoid this, it is recommended to set the Auto
keystone function to Off while the corner keystone
function is activated.
The top left corner adjustment as an example:
Press the Point ▼
button
Keystone
Keystion
Basic Operation
AUTO SET button
POINT ▲▼◄►
buttons
KEySTONE button
Keystone
Press the Point ►
button
5