Installing The Projector In Proper Directions - Sanyo PJ LINK PLC-XU106K Owner's Manual

Installing the Projector in Proper Directions

Use the projector properly in specified positions. Improper positioning may reduce the lamp life and result in severe
accident or fire hazard.
This projector can project the picture upward, downward, or backward, perpendicular to the plane of the screen as
shown in the figure below.
Bottom Front
Downward Upward
(Usual)
Be sure to set the Lamp control in High and the Fan
control in On 3 in the setting Menu when using the
projector inclined at between +40 degrees to +140
degrees to the horizontal plane at altitudes between
0 and approximately 1,600 meters above sea level.
Be sure to set the Fan control in On  when using
the projector at higher altitudes than the altitudes
described above, regardless of the installation
position of the projector. (p.57)
Positioning Precautions
Avoid positioning the projector as described below when installing.
10˚
Do not roll the projector more than 10 degrees from side to side.
10˚
Do not put the projector on either side to project an image.
10˚
10˚
In upward projection, do not tilt the projector over 10 degrees right and left.
In downward projection, do not tilt the projector over 10 degrees right and left.
10˚ 10˚
Bottom Front
Upward Downward
Safety Instructions
140º
50º 50º
90º
40º 40º
180 º 0º