Zoom And Focus Adjustment; Auto Setup Function; Keystone Correction - Sanyo PLC-WXU700 Owner's Manual

Basic Operation

Zoom and Focus Adjustment

Rotate the Zoom Lever to zoom in and out.
Rotate the Focus Ring to adjust the focus of the image.

Auto Setup Function

Auto setup function is provided to automatically execute
the setting of Auto setup (includes Input search, Auto PC
adj. and Auto Keystone functions) in the setting menu by
just pressing the AUTO SETUP/CANCEL button on the top
control or the AUTO SET/CANCEL button on the remote
control. Refer to page 48 for the setting of the Auto setup
function.
Note:
• Auto Keystone corrects vertical distortion only; it does
not correct horizontal distortion.
• Auto Keystone cannot work when Ceiling feature is set
to On in the Setting menu (p.53).
• Perfect correction of the image distortion cannot be
ensured with the Auto setup function. If the distortion
cannot be corrected properly by pressing the AUTO
SETUP/CANCEL or AUTO SET/CANCEL button, adjust
manually by pressing the KEYSTONE button on the
remote control or selecting Keystone in the Setting
menu (p.49).
• Fine sync, Total dots, Horizontal and Vertical
position of some computers cannot be fully adjusted
with the Auto PC adjustment function. When the image
is not provided properly with this operation, manual
adjustments are required (pp.34-35).

Keystone Correction

If a projected picture still has keystone distortion after
pressing the AUTO SETUP/CANCEL button on the top
control or the AUTO SET/CANCEL button on the remote
control, correct the image manually as follows:
Press the KEYSTONE button on the remote control. The
Keystone dialog box appears. Use the Point
correct keystone distortion. The keystone adjustment can be
stored (see page 49).
Reduce the upper width
▲
with the Point button.
6
buttons to
▲▼
Reduce the lower width
▼
with the Point button.
Zoom Lever
Focus Ring
Top Control
AUTO SETUP/CANCEL button
POINT ▲▼buttons
Remote Control
KEySTONE button
AUTO SET/CANCEL button
POINT ▲▼ buttons
• The white arrows indicate that there is no
correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the
remote control once more while the keystone
dialog box is being displayed, the keystone
adjustment will be canceled.
• The adjustable range is limited depending on the
input signal.