Table of Contents
Advertisement
PRODUCT IDENTIFICATION
Six Piece Log Set
Left Side
Figure 1 - Product
Identifi cation
LOCAL CODES
Install and use appliance with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
25 West 43rd Street, 4th fl oor
New York, NY 10036
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02169-7471
UNPACKING
1. Remove logs and appliance base assem-
bly from carton(s).
COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS
These appliances are approved for installation in the US state of Massachusetts if the fol-
lowing additional requirements are met:
• Un-vented Room Heaters shall be installed in accordance with 527 CMR 30.
• Installation and repair must be done by a plumber or gas fi tter licensed in the Common-
wealth of Massachusetts.
• The fl exible gas line connector used shall not exceed 36 inches (92 centimeters) in length.
• The individual manual shut-off must be a T-handle type valve.
• Unvented appliances may NOT be installed in bedrooms or bathrooms.
• A working smoke detector must be installed in the area where vent-free appliances are
installed.
Seller of unvented propane or natural gas-fi red supplemental room heaters shall provide
to each purchaser a copy of 527 CMR 30 upon sale of the unit.
PRODUCT FEATURES
OPERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
both realistic fl ames and glowing coals. This
heater is designed for vent-free operation
with fl ue damper closed. It has been tested
and approved to the ANSI Z21.11.2 standard
for unvented heaters. State and local codes
in some areas prohibit the use of vent-free
heaters. This heater may also be operated as
126839-01D
Piezo
Igniter
Front
Flame Adjustment Knob
Control Knob
2. Remove all protective packaging applied
3. Check appliance for any shipping dam-
a vented decorative (ANSI Z21.60) product by
opening the fl ue damper.
SAFETY DEVICE
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free
room heaters. The ODS/pilot shuts off the
heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo Igniter. This system
requires no matches, batteries or other
sources to light heater.
SuperiorFireplaces.us.com
Base Assembly
NOTE: Do not pick up appliance base as-
sembly by burners. This could damage the
appliance. Always handle base assembly
by grate.
to logs and appliance for shipment.
age. If appliance is damaged, promptly
inform dealer where you purchased the
appliance.
CAUTION: Do not remove
the data plates from the grate
assembly. The data plates
contain important warranty
and safety information.
5
Hide quick links:
Advertisement
Table of Contents
