Table of Contents
Advertisement
22. Solid fuels shall not be burned in a fi replace
in which an unvented room heater or decora-
tive appliance is installed.
23. When installing as a vented appliance in a
manufactured home or mobile home, the
PRODUCT IDENTIFICATION
Left
Side
Piezo
Igniter
Optional
Remote
Control
Optional Selector Switch
Front
LOCAL CODES
Install and use appliance with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
25 West 43rd Street, 4th fl oor
New York, NY 10036
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02169-7471
UNPACKING
1. Remove logs and heater base assembly
from carton.
COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS
These appliances are approved for installation in the US state of Massachusetts if the fol-
lowing additional requirements are met:
• Un-vented Room Heaters shall be installed in accordance with 527 CMR 30.
• Installation and repair must be done by a plumber or gas fi tter licensed in the Common-
wealth of Massachusetts.
• The fl exible gas line connector used shall not exceed 36 inches (92 centimeters) in length.
• The individual manual shut-off must be a T-handle type valve.
• Unvented appliances may NOT be installed in bedrooms or bathrooms.
• A working smoke detector must be installed in the area where vent-free appliances are
installed.
Seller of unvented propane or natural gas-fi red supplemental room heaters shall provide
to each purchaser a copy of 527 CMR 30 upon sale of the unit.
126848-01B
Flame Adjustment Knob
Figure 1 - Product Identifi cation
2. Remove all protective packaging applied
3. Check appliance for any shipping dam-
data plates from the grate as-
sembly. The data plates contain
important warranty and safety
information.
SuperiorFireplaces.us.com
installation must conform with the Manu-
factured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 or when
standard is not applicable, with Manufac-
tured Home Installations Standard, ANSI/
NCSBCS A225.1/NFPZ 501A.
Log Set
Base Assembly
Control Knob
NOTE: Do not pick up appliance base as-
sembly by burners. This could damage the
appliance. Always handle base assembly
by grate.
to logs and appliance for shipment.
age. If appliance is damaged, promptly
inform dealer where you purchased the
appliance.
CAUTION: Do not remove the
Right
Side
5
Advertisement
Table of Contents
