Intermec PB20 Quick Start Manual page 13

Printer Self-Test
1 Press the Paper Advance (red) button for at least five seconds
to run a Self-Test. Verify that the RF Module Power is On.
S This means you will be holding it long enough to hear the
beep and complete a paper advance.
S The self-test indicates the current state of your printer.
S Verify the current mode by reading the Power status line
from the printout.
Note: When shipping your printer via air freight,
turn the wireless printing mode off and set to serial
so that the radio is not enabled.
700 Mobile Computer Preparation
1 On your mobile computer, tap the Bluetootht icon located
in the System tray on the Today screen.
2 Select Advanced Features → Bluetooth Devices.
3 From the Tools menu, select Device Discovery. You are pre-
sented with a couple of screens detailing the device discovery
process.
4 You are now presented with a screen allowing you to modify
the selection parameters. The default should work for your
needs.
5 Click Next to proceed. A search for Bluetooth devices is per-
formed followed by a look-up of discovered device names.
The progress bars indicate the inquiry status.
6 A list of discovered devices displays:
S If your remote wireless printer is discovered and presented
in the list, select the appropriate check box and click
Next.
S If your remote device is not displayed, ensure that the de-
vice and its radio are switched On. Click Next, then select
Finish.
7 A progress bar appears indicating Service Discovery is being
performed.
If the discovery is successful a screen with Successful discovery
displays. Click Finish. The remote device icon appears in the
PB20 Printer Quick Start Guide
13