Intermec PB20 Quick Start Manual page 12

S Install the screws enough so they are fully seated but
not any further or you will strip the screw holes in the
printer case.
12 Carefully seat the printer in the case, you do not want to
pinch the wires between the printer mechanism and the
case.
Replace the four screws securing the printer mechanism to
13
the printer case.
14 Charge the battery 2-3 hours using your AC adapter or
cigarette lighter adapter.
Properly dispose of the used battery pack.
15
Using Your Printer with Serial Connection
1 Attach the Mobile Computer to Printer cable.
Computer to Printer Jack
Mobile Computer to Printer Cable
2 As you use the printer the power comes from the battery in
the printer. When the printer battery runs down the printer
will not operate until the battery is recharged.
PB20 Printer using Wireless Printing
Serial/Wireless Mode
Your printer comes to you as a serial mode printer. To switch
the mode to Wireless Printing it is necessary to toggle the mode
via the self-test function of the printer.
Performing the self-test indicates the current mode of the print-
er. The mode displays on the ticket and an audible indication
sounds. Each time the self-test function is performed the mode
will toggle between wireless printing and serial modes.
12 PB20 Printer Quick Start Guide