Intermec PB20 Quick Start Manual page 11

5 Gently disconnect the keyed battery pack connector (with
the black and red wires) from the board assembly. You
may find that you have to wiggle the connector a bit to
remove it from the connector.
Underside of battery
compartment
5b
Keyed battery pack
cable
6 Once the cover is removed gently tap the cover in your
hand or lift up on one of the battery retaining foam strips
to separate the battery pack from the cover.
7 Insert the new battery pack into the battery cover.
8 Reinstall the battery cover.
9 Reconnect the keyed battery cable. Routing the battery
pack wires is very important.
S The wires must not be pinched or crimped when rein-
serting the printer mechanism into the printer case.
10 Reposition the battery pack assembly on the printer
mechanism.
Replace the four screws to secure the battery pack cover to
11
the printer mechanism.
PB20 Printer Quick Start Guide
5a
Keyed battery pack
connector
11