Extras Menu - Siemens SINAMICS IOP-2 Operating Instructions Manual

Screen displays successful
download
Copying IOP-2 parameter sets
When you have saved a number of parameter sets to an IOP-2, it is possible to copy your
saved parameter sets to another IOP-2 using the simple process outlined below.
1. Connect the IOP-2 via the USB connector to a PC.
2. The IOP-2 will enter the "Mass Storage Device" Mode.
3. On the PC, navigate to the "ifs/config" folder.
4. Select the parameter sets you require and save them to a new folder on the local drive of
the PC.
5. Disconnect the IOP-2 from the PC.
6. Connect another IOP-2 and copy the saved parameter sets to the "ifs/config" on the new
IOP-2.
This procedure can be repeated for any number of IOP-2s.
7.6

Extras Menu

Overview
The Extras menu presents a number of options for the
configuration of the IOP-2, these are explained in this
section.
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 04/2017, FW V2.0, A5E39549448B AA
Screen returns to Status
Screen
Menu
7.6 Extras Menu
51