Device Configuration - Omron E2E series Network Connection Manual

5.2. Device Configuration

The hardware components to reproduce the connection procedures in this document are as
follows:
Personal computer
(Sysmac Studio and
CX-ConfiguratorFDT installed,
OS: Windows 7)
USB cable
Manufacturer
OMRON NJ-series CPU Unit
(Built-in EtherCAT port)
OMRON Power Supply Unit
OMRON Sysmac Studio
OMRON CX-ConfiguratorFDT
- Personal computer
(OS: Windows 7)
- USB cable
(USB 2.0 type B connector)
OMRON Ethernet cable
(with industrial Ethernet connector)
OMRON NX-series
EtherCAT Coupler Unit
OMRON NX-series
IO-Link Master Unit
- Unit power supply (24 VDC)
- I/O power supply (24 VDC)
OMRON IO-Link Proximity Sensor
Precautions for Correct Use
The connection line of EtherCAT communications cannot be shared with other Ethernet
networks. Do not use devices for Ethernet such as a switching hub.
Use an Ethernet cable (double shielding with aluminum tape and braiding) of Category 5 or
higher, and use a shielded connector of Category 5 or higher.
Connect the cable shield to the connector hood at both ends of the cable.
Precautions for Correct Use
Update Sysmac Studio and CX-ConfiguratorFDT to the version specified in this Clause 5.2.
or to a higher version. If you use a version higher than the one specified, the procedures and
related screenshots described in Section 7. and subsequent sections may not be applicable.
In that case, use the equivalent procedures described in this document by referring to the
Sysmac Studio Version 1 Operation Manual (Cat. No. W504) and ConfiguratorFDT Online
Help.
5．Applicable Devices and Device Configuration
NJ501-1500
(Built-in EtherCAT port)
Ethernet cable
Unit power supply
I/O power supply
Name
NJ501-1500
NJ-PA3001
SYSMAC-SE2[][][]
(Included in Sysmac Studio) Ver.2.2
-
-
XS5W-T421-[]M[]-K
NX-ECC202
NX-ILM400
-
-
E2E-X3B4-IL3 2M
NX-ECC202＋
NX-ILM400
E2E-X3B4-IL3 2M
Model Version
Ver.1.12
Ver.1.16
Ver.1.2
Ver.1.0
Ver.1.00
6