Using The Audio Output Jacks; Using The Audio/Video Input Jacks For Pip - Sanyo AVM-3280G, AVM-3680G Owner's Manual

USING THE AUDIO OUTPUT JACKS

CONNECTING A STEREO AMPLIFIER TO AUDIO OUT JACKS
1. Connect the TV Audio Output (R/L)
2. Press POWER on remote control to turn on the TV. Turn on external equipment also.
UHF/VHF/CATV
75Ω S-VIDEO IN -1
R
AUDIO
AUDIO
VIDEO
INPUT
1
AUDIO
VIDEO
INPUT
2
R AUDIO
Back of TV
MODEL AVM-3680G
USING THE AUDIO/ VIDEO INPUT JACKS
FOR PIP
The PIP feature requires two signals to work: You must connect signals to the 75 ohm
terminal and to one set of the A/V jacks; or you must connect signals to both sets of A/V jacks.
CONNECTING A SATELLITE SYSTEM AND CABLE
1. Connect signal (cable or antenna) to the TV 75Ω (ohm) terminal
2. Connect Satellite S-Video Out to TV S-Video In jack.
Using the S-Video In 1 jack overrides the Video1 Input jack and the S-Video In 2 jack
overrides the Video2 In jack (Model AVM-3680G).
3. Connect the Satellite Audio Out (R/L) jacks to TV Audio Input (R/L) jacks.
Press POWER key to turn on the TV. Turn on external equipment also.
Cable or Antenna
system
(See page 4.)
to the Stereo Amplifier In (R/L)
S-VIDEO IN -2
(MONO)
L VIDEO
L
R
VIDEO
L AUDIO
OUTPUT
(MONO)
CATV IN
CH3
CH4
OUT TO TV
Back of
Satellite
Receiver
S-VIDEO IN -1
UHF/VHF/CATV
75Ω
AUDIO
AUDIO
R
VIDEO
INPUT
1
AUDIO
VIDEO
INPUT
AUDIO
R
2
Stereo Amplifier
.
VIDEO R- AUDIO -L
S-VIDEO
VIDEO R- AUDIO -L
S-VIDEO IN -2
(MONO)
L VIDEO
L
R
Back of TV
AUDIO
VIDEO
L
(MONO) OUTPUT
(MODEL AVM-3680G)
.
QuickTips
Position your TV at
least 2 feet from
stereo speakers. The
magnets in the speak-
ers may affect the
picture quality.
D
O NOT
external speakers
directly to the TV.
Always match cables
according to the
colors;
audio,
audio and
video.
Make sure all cable
connectors are fully
seated on the jacks.
Make sure you select
TV channel to match
your VCR output
(Ch. 3 or 4). See
chart on page 15.
To view two TV
programs or watch a
TV program and pre-
recorded tape at the
same time follow
steps on page 14.
IN FROM
If you are connect-
SAT.
ing your TV to a
satellite dish, you
must have two (2)
receivers or use a
cable system or
antenna with the
satellite to use the
PIP feature.
connect
for right
RED
for left
WHITE
for
YELLOW
13