Setting Up Screen Call; Activating Screen Call; Selecting An Announcement For Screen Call; Recording Name For A Pre-Recorded Announcement - Sanyo SCP-7050 User Manual

Setting Up Screen Call

This feature enables you to screen incoming calls by using a
recorded announcement, either one that is pre-recorded or one
that you have recorded. You can also record the caller's message
into the Voice Memo list.

Activating Screen Call

To start Screen Call when you have incoming calls:
When the phone rings or vibrates, press
softkey) > Screen Call.
To set Auto Screen Call:
1. Press
Memo
2. Set the answer delay by using numeric keys or by pressing the
navigation key up or down.
3. Press
or
Standby display.
Tip:
While the caller's message is being recorded, press
the call, or press

Selecting an Announcement for Screen Call

1. Press
Memo
2. Depending on your preference, select Pre-Recorded or Custom.

Recording Name for a Pre-Recorded Announcement

1. Press
Memo
2. Highlight Pre-Recorded and press
Record Name.
If your name has already been recorded, select Yes or No
for overwriting.
3. Press
to start the 1st recording. (The maximum recording
time is 12 seconds.)
4. Press
to stop recording.
5. After the 1st recording, press
recording.
6. Press
to stop recording.
(right softkey) > Screen Call > Auto > On.
(left softkey). The
OK
to stop recording and disconnect the call.
(right softkey) > Screen Call > Announcement.
(right softkey) > Screen Call > Announcement.
Options
icon is displayed on the
(right softkey) >
Edit
again to start the 2nd
(right
to answer
87