AUXILIARY CABLE CONNECTIONS
Each Cable Assembly is 3-1/2 feet long and is composed of a 6-conductor
shielded flat cable with PVC jacket. Ten-foot and fifteen-foot cables are also
available. Six pin modular plugs are attached at each end. Refer to the
following chart for pin output:
Pin
1
2
3
4
5
6
For level detector (sensors) connections, cut off one end of the six conductor
flat cable, or cut the cable in half, if using longer cables, to make two pieces.
Strip the shield (metal) and plastic jacket back two inches. Spread the wires.
Strip back one inch of the black wire, pin 1, and white wire, pin 2. Fold the
other wires back along the plastic jacket and tape or cut off as desired. Twist
one lead of the level detector to the black lead of the cable, pin 1, and twist the
other lead of the level detector to the white lead of the cable, pin 2. Solder the
two connections together or use a wire nut if possible. Tape around exposed
bare wire areas.
APPENDIX A
Signal
Ground
Contact Closure or Logic Low
Input
12V DC
Capacitive Plate Input
Capacitive Plate Input
Shield Guard
Figure A-1. Level Sensor Connections
22
Color
Black
White
Red
Green
Brown
Bare Tin
Printed in U.S.A.
030800