Maintenance; Cleaning - Martin RUSH CS Series User Manual

Maintenance

Warning! There are no user-serviceable parts inside. Do not open the housing. Refer any
service operation not described in this manual to Martin Professional™ or its authorized
service agents.
Installation, on-site service and maintenance can be provided worldwide by the Martin
Professional™ Global Service organization and its approved agents, giving owners access
to Martin's expertise and product knowledge in a partnership that will ensure the highest
level of performance throughout the product's lifetime. Please contact your Martin® supplier
for details.
Never try to repair the fixture by yourself as this may result in damage or malfunction and it
may potentially void your product warranty. The only service operation the user can carry
out on RUSH® CS Series fixtures is occasional cleaning.
Be aware that the output of LEDs, like all light sources, changes gradually over many thousands of hours
of use. If you require products to perform to very precise color specifications, you may eventually need to
make small readjustments at the lighting controller.
The light source in this product is not user-replaceable. When the light source LEDs reach the end of their
service life, they may be replaced only by Martin® Service, an authorized Martin® Service agent or a
similarly qualified person.

Cleaning

Regular cleaning is essential for fixture life and performance. Buildup of dust and dirt degrades the
fixture's light output and cooling ability.
Cleaning schedules will vary greatly depending on the operating environment. It is therefore impossible to
specify precise cleaning intervals for the RUSH® CS Series. Inspect fixtures within their first few weeks of
operation to see whether cleaning is necessary. Check again at frequent intervals. This procedure will
allow you to assess cleaning requirements in your particular situation. If in doubt, consult your Martin®
dealer about a suitable maintenance schedule.
Do not use products that contain solvents, abrasives or caustic agents for cleaning, as they can cause
surface damage to the fixture. The aluminum housing and front cover can be cleaned with a soft cloth
moistened with mild detergents such as those for washing cars.
To clean the fixture housing and front cover:
1. Isolate the PSU from AC power and allow the fixtures to cool for 20 minutes.
2. Wipe each fixture clean with a soft dry or damp cloth.
Updating firmware
If Martin® releases updated firmware for this fixture, you can install it using the Martin® Companion
application running on a Windows PC. See www.martin.com for details.
18
RUSH® CS Series User Manual