BEA Spotfinder Infrared Zone Locator User Manual

1 Description & Specifi cations
BEA's Infrared (IR) Spotfi nder is a
hand-held tool used to locate an
active infrared source.
This easily locates an IR area
which can be used to assist in the
palcement of the sensing zone as
well as approximate the distance
from a sensor.
The Spotfi nder has two settings,
(1) LED only (light, no sound) or
(2) LED and Buzzer.
This accessory will shut-off after
45 seconds of no IR activity. To
reactivate, switch OFF then back
ON by selecting either LED or
BUZZER.
DESCRIPTION
POWER SUPPLY AAA Alkaline Batteries (2) Included
DIMENSIONS
MATERIAL
2 Settings & Placement
For sliding door overhead presence detection, place the Spotfi nder fl at on the fl oor so that the IR-SPOT is at the appropriate
distance from the door face. Adjust the IR Curtain on the sensor until the LED turns Orange and/or the Buzzer begins to beep
(as in Position 2 below).
NOTE: The Spotfi nder only serves to identify an area of infrared light and not necessarily imply the area of the sensors detection.
BEA, Inc. always recommends a walk test to ensure compliance to all applicable standards for sensing patterns.
75.0176.04 20080331
SPECIFICATION
3" X 2 1/4" X 1" (76mm x 57mm x 25mm)
ABS Plastic
POSITION
N/A
'GREEN' LED FOR POSITION
LED COLOR
1 GREEN
2 ORANGE
3 RED
FLASHING ORANGE
SPOTFINDER
USER'S GUIDE
INFRARED ZONE LOCATOR
'ORANGE' LED FOR POSITION
LED COLOR: POSITION
'RED' LED FOR POSITION
BUZZER LEVEL IR LIGHT LEVEL
NONE
SOFT - WEAK
LOUD - STRONG
LOW BATTERIES
See ANSI
A156.10 for
Required
Distance
NONE
LOW
HIGH
Page 1 of 2