Adjusting The Airflow Direction - Sanyo CH0951 Technical & Service Manual

1. Horizontal
CAUTION
2. Vertical
ON
1HR.
TIMER TEMP.
OFF
FLAP FAN SPEED MODE
ON OFF
NIGHT
SET CANCEL SETBACK
ACL
BATTERIES
A. Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
NOTE
CAUTION
OI-202-23EG

Adjusting the Airflow Direction

The horizontal airflow can be adjusted by moving the vertical vanes with
your hands to the left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical vanes
are positioned all of the way to the right or left, condensation may begin
to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote
control unit. Do not move the flap with your hands. Confirm that the remote
control unit has been turned on. Use the FLAP button to set either the
sweep function or one of the six airflow direction settings.
(The maximum capacity is obtained at the position at
B. Setting the airflow manually
•
The flap automatically closes when the unit is off.
•
During the heating operation, the fan speed will be very low and the
flap will be in the horizontal position (position
blown out of the unit begins to warm. Once the air warms up, the flap
position and fan speed change to the settings specified with the remote
control.
•
Use the FLAP button on the remote control to adjust the position of the
flap. If you move the flap by hand, the flap position according to the
remote control and the actual flap position may no longer match. If this
should happen, shut off the unit, wait for the flap to close, and then turn
on the unit again; the flap position will now be normal again.
•
Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
4
.)
SWEEP
COOL
and
DRY
SWEEP
HEAT
Referring to the above illustration, use
the FLAP button to set the airflow
direction within the range used during
the heating, cooling, or dehumidifying
operation.
6
) until the air being
6
5
4
3
2
1
21