Adjusting The Fan Speed - Sanyo CH0951 Technical & Service Manual

NOTE
3. Adjusting the
Fan Speed
A. Automatic
Cooling and DRY mode:
Heating mode:
B. Manual
OI-202-17EG
Operation with the Remote Control Unit (continued)
This appliance has a built-in 5-minute time delay circuit to ensure
•
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the unit
will restart automatically after five minutes.
Simply set the FAN SPEED selector button to the
A microcomputer in the air conditioner automatically controls the fan speed
when the mode is selected. When the air conditioner starts operating,
the difference between the room temperature and the set temperature is
detected by the microcomputer which then automatically switches the fan
speed to the most suitable level.
When difference between
room temperature and set
temperature is
4 F and over
Between 4 F and 2 F
Below 2 F
When difference between
room temperature and set
temperature is
4 F and over
Below 4 F
If you want to adjust fan speed manually during operation, just set the FAN
SPEED selector as desired. [
position.
FAN SPEED
High
Medium
Low
FAN SPEED
High
Medium
, , or ]
15