Dukane 9100WUSS User Manual page 56

SETUP menu
Item
STANDBY MODE
OSD MESSAGE
56
Switches the standby mode setting.
NORMAL ó SAVING
• When SAVING is selected, the RS-232C communication control
except to turn the projector on and the network function are disabled
while the projector is in the standby mode.
• When SAVING is selected, the CENTERING feature while the
projector is in the standby mode is disabled.
• When SAVING is selected, the HDBaseT functions are disabled
while the projector is in the standby mode.
Switches how to display the OSD messages.
■NORMAL : All message functions work.
■SILENT : The following message functions do not work.
"AUTO IN PROGRESS" while automatically adjusting.
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ."
"NOT AVAILABLE"
"Searching...." while searching for the input.
"Detecting...." while an input signal is detected.
The indication of the ZOOM displayed by changing.
*While operating from the remote control only.
The indication of the FOCUS displayed by changing.
The indication of the input signal displayed by changing.
The indication of the aspect ratio displayed by changing.
The indication of the PICTURE MODE displayed by changing.
The indication of the MY MEMORY displayed by changing.
The indication of "FREEZE" and "II" while freezing the screen by
pressing the FREEZE button.
The indication of the TEMPLATE displayed by changing.
The indication of the ECO MODE displayed by changing.
■INHIBIT : All message functions do not work.
The only buttons will function are as below.
STANDBY, ON
• To change this function, follow the steps below.
1. Press the OSD MSG button on the remote control for 3 sec.
2. The INHIBIT OSD will be displayed.
While this OSD is displayed, press the OSD MSG button again
on the remote control.
3. Toggle and change the function.
NORMAL ó SILENT ó INHIBIT
Description