Safety - Thermador PH60GS Installation Instructions Manual

Safety

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: Please leave these Instructions with this unit
for the owner. Save these Instructions for the Local
Inspector's use.
OWNER: Please retain these instructions for future
reference.
WARNING
If the information in this manual is not followed exactly, fire
or shock may result causing property damage or personal
injury.
DO NOT repair or replace any part of the appliance
unless specifically recommended in the manuals.
Improper installation, service or maintenance can cause
injury or property damage or void product warranty. Refer
to this manual for guidance. All other servicing should be
done by an authorized servicer.
CAUTION
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least two
people must be used in moving the hood to
avoid injury and to avoid damage to the unit or
the floor.
Rings, watches, and any other loose items that may
damage the unit or otherwise might become entangled
with the unit should be removed.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
WARNING
Repairs should only be done by a trained servicer.
Improper repair of your appliance may result in risk of
severe physical injury or death.
WARNING
When properly cared for, your new appliance has been
designed to be safe and reliable. Read all instructions
carefully before use. These precautions will reduce the
risk of burns, electric shock, fire, and injury to persons.
When using kitchen appliances, basic safety precautions
must be followed, including these in the following pages.
Installation Instructions
Safety Codes and Standards
This appliance complies with the following Standards:
• UL 507, Standard for the Safety of Electrical Fans
• CAN/CSA-C22.2 No. 113, Fans and Ventilators
It is the responsibility of the owner and installer to
determine if additional requirements and/or standards
apply to specific installations. Always refer to local codes to
ensure all requirements are met.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
INSTALLER — show the owner the location of the circuit
breaker. Mark it for easy reference.
WARNING
Turn off power circuit at service panel and lock out panel
before wiring this appliance. Requirement: 120 VAC, 60
Hz 20 A. Allow the appliance to cool after the power has
been turned off before servicing the appliance.
WARNING
To reduce the risk of fire use only metal ductwork.
CAUTION
Vent unit to the outside of building only. This unit is only
designed to be vented outside. It should not be used for
recirculation mode.
Never modify or alter the construction of the appliance. For
example, do not remove panels or wire covers.
Examine the appliance after unpacking it. In the event of
transport damage, DO NOT plug it in.
English | 3 |