Error Code H1-06 Failure Detection Procedure - Denon AVR-X2400H Service Manual

3-4. Error Code H1-06 failure detection procedure

Checking device. [U1026 : ADV8003]
Check the power supply voltage.
Check item(21). Check the power supply voltage.
:
Does the power supply voltage of the GUI [U1026]
indicate the appropriate voltage (1.8V, 3.3V)?
The test points are as follows.
L1046
1.8V
L1043
3.3V
U1026
YES
The GUI [U1026] is faulty.
Replace with a new device.
Recheck from check item (1).
If it does not work, replace the PCB.
NO Check item(22). Check the power supply voltage.
:
Check the power supply components [U1069,
Q1063] on the substrate and peripheral pattern.
If there is no problem, remove the GUI [U1026]
from the substrate and measure the voltage at
the test point of check item (21).
Is the voltage correct (1.8 V or 3.3 V)?
YES NO
The power supply circuit is faulty.
Replace the PCB.
Checking the reset waveform.
Check item(23). Checking the reset :
Check the CPU.
Is the waveform of the TP near the GUI [U1026] correct (like the one
shown in the diagram) when the power is turned on?
RESET
U1026
YES NO
Check the reset circuit between CPU [U1018] and GUI [U1026].
If there is no problem, the GUI [U1026] is faulty.
Replace with a new device.
Recheck from check item (1).
If it does not work, replace the PCB.
96
10ms
10ms
Example of the waveform to be checked
Voltage scale：1.0V/div
Time scale：20ms/div
Go to next page.
10ms