PROGRAMMING GUIDE
Programming Options
Your Curtis TLP brewer is factory preset for optimal performance. Generally, there will not be a need to change the
programming. If necessary, the following operating parameters can be changed:
•
Brew temperature
•
Brew volume (FULL and HALF BREW)
•
Pulse brew
You can also access the brew counter to read the number of brew cycles the brewer has performed. In the event of
a power loss, the brewer will remember ALL program setting.
Changing the Brew Temperature (Factory Default: 200° F/93° C)
The following steps can also be used to read the existing temperature setting. The brew temperature range is
170° to 206°F.
1
The rear toggle switch must be in the ON
position. The control panel must be off (power
light off). Press the POWER button if necessary.
2
Press and hold the HALF BREW button. Press
and release the POWER button.
3
Continue to hold down the HALF BREW button
until the READY light
4
# of Flashes
5
To exit without changing the temperature, press the POWER button. To change the temperature, press and hold
temperature is indicated according to TABLE 1.
6
Press the POWER button to set and exit.
, then release the HALF BREW button.
Temperature
1
170°F/77°C
2
172°F/78°C
3
174°F/79°C
4
176°F/80°C
5
178°F/81°C
6
180°F/82°C
7
182°F/83°C
8
184°F/84°C
9
186°F/86°C
10
188°F/87°C
TABLE 1
POWER
# of Flashes
Temperature
11
190°F/88°C
12
192°F/89°C
13
194°F/90°C
14
196°F/91°C
15
198°F/92°C
16
200°F/93°C
17
202°F/94°C
18
204°F/96°C
19
206°F/97°C
PG10