Curtis TLXG0201S000 Service Manual

F
IND OUT MORE
.
ON THE WEB
WILBURCURTIS.COM
SERVICE MANUAL – MODEL TLXG0201S000
USING THE THERMOPRO SERVER
WARNING – THERMOPRO SERVERS MAY BE HEAVY WHEN FILLED. CARE MUST BE TAKEN
WHEN TRANSPORTING TO AVOID DROPPING OR SPILLING.
Use only coffee or water in the insulated dispenser. Do not use the airpot to dispense any other beverage.
Preheating the airpot is recommended.
1. Place a clean and empty server centered under one of the brewcones of the ThermoPro brewer.
2. Make sure the READY TO BREW indicator is lit.
3. Fill brewcone with the correct measure of ground coffee.
4. Press the desired brew button on the side of the brewer with the empty airpot. The ThermoPro airpot
employs the Curtis Brew-Thru lid and it is not necessary to remove the top lid before brewing.
5. Allow the brewcone to completely drip before removing airpot for remote service.
SERVICING AIRPOT/THERMOPRO SERVER
Completely clear the unit of any coffee by opening the faucet to drain over a sink. Unscrew and remove the lid
and tube assembly.
1. REPLACING THE GAUGE GLASS
The gauge glass can be removed for maintenance or to replace if broken.
1. Carefully take hold of the gauge glass guard and lift away the guard from the
front of the unit.
2. The sight glass guard contains two extra glass tubes for replacing a broken
gauge glass. These are held in slots designed into the guard that run the
length of the guard (see fig. 1).
3. Once the gauge glass guard is removed, you will observe that the gauge
glass is held by the black plastic elbow at the top. Pull back on the gauge
glass tube while slightly lifting at the elbow (flexible silicone fitting at the elbow
will allow you to tilt the gauge glass tube). Lift the gauge glass out from the
top of the faucet.
4. The glass tube will come out with a small silicone seal attached, one on each
end. You can pull these off for cleaning (take care to replace the silicone seal
as it was removed, with the large opening sliding over the glass tube).
2. REMOVING THE BASE ASSEMBLY
Remove the base assembly for faucet repair or to move the body of the unit
for placement on a remote serving stand.
1. Remove the wing nut at the centerline of the ThermoPro.
2. Pull tab, left side (fig. 2.).
3. Hold the handle and Twist ¼ turn to lift off of base. Before lifting off the unit,
please notice the mark on the bottom right edge of the airpot marked, "ALIGN
TO INSTALL". This will assist in the assembly of the base and body of the unit.
3. REMOVING THE FAUCET
To replace the faucet or the silicone elbow fitting for repair or cleaning:
1. Remove the base assembly as described above.
2. Remove the Liner Mounting Retainer at the bottom of the liner (held in place by
a black plastic nut). There is a key slot in the stainless body of the unit that aligns
with a pin on the liner retainer for assembly.
W C
ILBUR URTIS
C , I
OMPANY NC
.