Table of Contents
Advertisement
SanDisk uSSD 5000
2.6
System Reliability
Specification
Data Reliability
Data integrity after power loss
Bad blocks
Wear-leveling
2.6.1 MTTF
The reliability figure of merit most often used for electronic equipment is Mean
Time To Failure (MTTF). SanDisk estimates MTTF using a prediction
methodology based on reliability data for the individual components in
SanDisk products.
Component data comes from several sources: device life tests, failure analysis
of earlier equipment, device physics, and field returns.
SanDisk uses following methods to predict reliability:
Telcordia Special Report SR-332, Reliability Prediction Procedure for
Electronic Equipment (RPP).
British Telecom Industry HRD5, Handbook of Reliability Data for Electronic
Components used in Telecommunication System.
Table
6
summarizes
configurations. The analysis was performed using a RAM Commander™ failure
rate prediction.
Failure Rate: The total number of failures within an item population,
divided by the total number of life units expended by that population,
during a particular measurement interval under stated condition.
Mean Time To Failures (MTTF): A basic measure of reliability for
repairable items: The mean number of life units during which all parts of
the item perform within their specified limits, during a particular
measurement interval under stated conditions.
Product
1GB, 2GB, 4GB
8GB, 16GB
© 2008 SanDisk® Corporation
Table 5: Reliability
Parameters
Error detection / error correction based on
BCH algorithm
Data is guaranteed after power loss
Transparent bad block management
Dynamic and Static Wear-leveling
the
MTTF
prediction
Table 6: uSSD MTTF
Condition
Telcordia SR-332, GB, 25°C
Telcordia SR-332, GB, 25°C
9
results
for
various
MTTF (Hours)
10M
8M
October 2008, Document no. 80-36-03353
Product Manual
uSSD
Advertisement
Table of Contents
