Complete The Finished Wall - Kohler K-1630 Installation Manual

7. Complete the Finished Wall

If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Apply a continuous bead of silicone sealant to the nailing-in flanges. Install water-resistant wall
material so the paperbound edge is at least 1/4" (6 mm) above the finished, concave surface of the
whirlpool.
Tape and mud the water-resistant wall material. Install the finished wall material.
Install the mixing valve, shower, and spout trim according to the instructions packed with the trim.
Install any extra grab bars or towel bars to the bridging previously installed. Follow the accessory
manufacturer's instructions.
Install the shower door according to the manufacturer's instructions.
Kohler Co.
Install water-resistant wall
material so the paperbound
edge is at least 1/4" (6 mm)
above the finished, concave
surface of the whirlpool
Apply a continuous
bead of silicone sealant
to the nailing-in flanges
Concave Surface
9
Stud
1015417-2-C