Float Input; Output Pins - Teledyne Platinum Pocket Manual

Platinum/Optima CVE Refrigerated Sampler
ON: If the sampler fails to detect liquid, it will
try again up 4 times to collect the sample.

3.3.6 Float Input

Depending if the F
been factory-configured, enabling this input
will configure the sampling program to delay
sample collection until that circuit closes and
subsequently either:
• Float Start: continue sampling even if
the float circuit reopens,
• Float Start/Stop: toggle the collection of
samples on and off as the rising and
falling stream level closes and opens that
circuit. This feature may be used with
full bottle shut off for composite samples.
The sampler controller is D
1 and 2 are open of the external 7 pin connector
(orange wires). The controller is E
pins 1 and 2 are closed.

3.3.7 Output Pins

An alarm output is based one of the following
events:
• Program Done: This event occurs when
a running sampling program has finished
3-10
I
LOAT NPUT
Toggle to change
Disable/ Enable
and press Enter.
If Disable the option
is turned off.
ISABLED
options have
when pins
NABLED
when