Samsung SilverCare SilverCare Washer Owner's Manual page 23

Code Symbol
Problem with control.
Electric service was lost when
Washer was running.
A fault is detected in the water
level sensor.
Jammed Key.
Motor speed sensor problem.
Temperature sensor problem.
High current detected.
High/Low voltage detected.
Vibration sensor problem.
SilverCare™ control problem
Too much SUdS is detected
during the washing session. And,
the unit is put on hold until the
suds get reduced. Then, it will go
back to the operation. When it
finishes washing, End and SUdS
codes will blink in turn.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
Troubleshooting
Meaning
Call for service. See below.
Restart the cycle by pressing the Cycle Selector
dial.
Call for service
Call for service
Restart the cycle.
If the code reappears, call for service, see below
Restart the cycle.
If the code reappears, call for service, see below
Restart the cycle.
If the code reappears, call for service, see below
Restart the cycle.
If the code reappears, call for service, see below
Restart the cycle.
If the code reappears, call for service, see below
Restart the cycle.
If the code reappears, call for service, see
below.
To prevent it, cut down on detergents.
SAMSUNG Clothes Washer Owner's Instructions E-4
Solution