Installation Instruction
Installer Setting - ESP Function
E.S.P function is setting the volume of each air flow. It is for the convenience of installation. It is recommended
that you should not use this function while using the wireless remote controller.
CAUTION
If you set ESP incorrectly, the air conditioner may malfunction.
This setting must be carried out by a certificated-technician.
100 unit 10 unit
AUTO INDOOR
REMO
ZONE 1
ZONE 2
ZONE 3
AUTO INDOOR
REMO
ZONE 1
ZONE 2
ZONE 3
* Slo and Po setting is not available for some products.
* Because the EPS value is already appropriately set when manufactured from the factory, it is recommended that
you do not change the ESP value.
12 Deluxe wired remote controller
ZONE 4
2TH
ZONE 4
1
Press the
button.
2
Press the
button.
3
Set the volume of each air flow (
using the
button. Press the
the air flow.
(The value of E.S.P could be adjusted from 1 to 255.)
(The figure on the left shows when the strong wind's
ESP value has been set to 212.)
4
If you press the
E.S.P value will be set and the setting mode will be
unset.
Lo¡Med¡Hi) by
button to select
button one more time, the