Installation instruction
Installer Setting-Zone Number Setting
This function is only available on some products.
Zone Number is to set the number of installed zones. It's possible to control only in zone new type
24 Wide Wired Remote Controller
1
Press
button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2
Repeat pressing
button to select
Function code 14.
Function Code
Zone Number installed
Ex) Setting the Zone Number for "2"
3
Select Zone Number by pressing
button
(02~04 : number of zone installed)
4
Press
button to save or release.
5
Press
button to exit or
system will automatically exit
after 25 seconds without any
input.
Installer Setting -Optional Function Setting
For the optional product such as PLASMA PURIFICATION/DEHUMIDIFIER/ ELECTRIC HEATER
and VENTILATION, ELEVATION GRILL.
It is possible to set the items are installed or not
Installation instruction
1
Press
button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2
Repeat pressing
button to select
function code.
(20: PLASMA PURIFICATION,
21: DEHUMIDIFIER,
22: ELECTRIC HEATER,
23: ELEVATION GRILL,
24: VENTILATION KIT)
Function Code
Existing condition
3
Select existing condition
of each mode by pressing
button.
(00: not installed,
01 : installed)
4
Press
button to save or
release.
5
Press
button to exit or
system will automatically exit
after 25 seconds without any
input.
Owner's & Installation Manual 25