Esp Function - LG PQRCFCS0C Owners & Installation Manual

Necessary functions before using

ESP Function

E.S.P function is setting the volume of each fan speed. It is for the convenience of installation. It is
recommended that you should not use this function while using the remote controller.
PQRCFCS0C
Defrost Preheat
TEMP
ROOM FAN
TEMP SPEED
TEMP
* The E.S.P value is set at the proper value at the factory. So it is highly recommended that you should do not
change the E.S.P value at your discretion.
12 Simple Wired Remote Controller
Out door
Room Temp
Total on
Central Run
1
Press the room temperature button and temperature
incrreasing button s same time for three seconds
2
Set the volume of each fan speed(Low, Medium, Hi)
by using the temperature control button. Press the fan
speed button to select the fan speed.
The value of E.S.P can be adjusted from 1 to 255.
3
If you press the On/Off button while setting the ESP
function, it will be canceled. (The picture on the left
side is the example of setting the Hi wind to ESP 10.)
4
Press the room temperature button and the
temperature increasing button (s) at the same time for
three seconds. Then the ESP setting will be activated
after the temperature display flashes three times.
EX)
Lo
200
Setting the Low wind to 210
Med
100
Setting the Medium wind to 175