Advertisement
V I I I .
DRIVE WHEEL
WASHER
DRIVE WHEEL NUT
Figure 31. Drive Wheel Removal
Battery Replacement
A battery wiring diagram is printed on a decal located on the frame near the rear battery. See the specification table for
correct battery specifications. See figure 33.
WARNING! Prevent injury. Do not replace battery when seat is occupied.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that
much weight, be sure to get help. Lifting beyond your capacity can result in personal injury.
WARNING! Prevent injur y and/or
equipment damage! Do not mix or
match new and old batteries. If you
encounter a situation where one
battery needs to be replaced, then
replace both batteries. Refer to
specifications table in this manual and/
or the manual supplied with the
battery charger for recommended type
and capacities.
To replace the batteries:
1. Turn off the power to the controller.
2. Remove the detent pin from the bottom of the foot
platform bracket. See figure 19.
3. Lift the foot frame straight up approximately 5 cm (2 in.)
and pull toward you to remove the foot platform.
4. Locate the two wiring harnesses that are attached to
the batteries.
5. Disconnect the wiring harnesses from their respective
quick disconnects on the frame by pulling the quick
disconnects toward you.
6. Remove the batteries from the power base assembly.
7. Disconnect the battery harnesses from the positive and
negative terminals on the batteries.
38
C A R E
A N D
www.pridemobility.com
M A I N T E N A N C E
TUBE
FRONT RIM HALF
Figure 32. Drive Wheel Disassembly
Figure 33. Battery Wiring Diagram
TIRE
REAR RIM HALF
QUICK DISCONNECTS
BATTERY TERMINALS
SCREWS
Jazzy 1402
Advertisement
