Advertisement
V .
C O M F O R T
A D J U S T M E N T S
Armrest Width Adjustment
To change the armrest width:
1. Locate the two adjustment knobs on the armrest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Retighten the knobs.
Armrest Angle Adjustment
You can adjust the armrest angle to fit your specific needs.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nuts. See figure 18.
3. Loosen the armrest angle adjusting screw.
4. Turn the screw clockwise to lower the front of the armrest, or turn the screw counterclockwise to raise the front of the
armrest.
5. Lock the adjusting screw into place by retightening the jam nuts.
Controller Position Adjustment
The controller can be positioned for either right- or left-hand use. It can also easily slide out away from the armrest, or in
toward the armrest.
To change the controller position:
1. Turn off the power to the controller.
2. Disconnect the controller connector(s) from the electronics tray.
3. Cut any wire ties securing the controller cable to the armrest.
4. Flip up the armrest and loosen the setscrew. See figure 13.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew(s) to secure the controller.
NOTE: If your power chair is equipped with a Synergy Seat or TRU-Balance Power Positioning System,
loosen the mounting screws (see figure 12) and remove the mounting block from the armrest. Transfer the
mounting block and controller to the opposite armrest and tighten the mounting screws to secure the control-
ler in place.
9. Use a wire tie to secure the controller cable to the armrest on a contour seat.
10. Plug the controller connector(s) into the power base.
To extend the controller:
1. Loosen the setscrew(s) on the underside of the armrest or in the mounting block. See figures 12 and 13.
2. Slide the controller mounting bracket into or out of the armrest to the desired position.
3. Tighten the setscrew(s).
26
www.pridemobility.com
Jazzy 1402
Advertisement
