Advertisement
V .
C O M F O R T
Anti-tip Wheel Adjustment
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are
preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may be
necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either of the
following occur:
When coming to a stop, your power chair tips forward excessively.
The anti-tip wheels constantly rub the ground.
NOTE: Each drive tire must be inflated to 35 psi (2.4 bar) in order for the anti-tip wheels to be properly
adjusted.
To adjust the anti-tip wheels:
1. Place a wrench on the inner locknut of the anti-tip bracket
located right after the shock strut. See figure 25.
2. Turn the locknut counterclockwise to loosen.
3. Place your wrench on the adjustable cam located on
the other side of the locknut. See figure 26.
4. To adjust the anti-tip upward, turn the cam counter-
clockwise. To adjust the anti-tip downward, turn the
cam clockwise.
5. Tighten the locknut.
WARNING! Consult your authorized
Pride Provider before attempting to
change the anti-tip height! Changing
the anti-tip wheel height affects
handling under deceleration!
WARNING! The higher you raise the
anti-tip wheels, the more tendency your
power chair has to tilt forward when
coming to a stop. You can compensate
for this by making a small adjustment
to the pre-programmed deceleration
setting in the controller or by moving
the seat assembly farther to the rear
of your Jazzy 1402. Failure to do so
may result in personal injury.
PROHIBITED! Do not remove the anti-
tip wheels.
30
A D J U S T M E N T S
Figure 25. Anti-Tip Bracket (Inner Locknut)
Figure 26. Anti-Tip Wheel Adjustment (Cam)
www.pridemobility.com
Jazzy 1402
Advertisement
