Symbols In This Manual; Attaching The Front Handle - Ryobi RLT26CDSE Original Instructions Manual

Wait for 10 seconds
Use unleaded petrol intended for motor
vehicle use with an octane rating of
91([R+M]/2) or higher.
Use 2-stroke lubricant for air cooled
engines.
Mix the fuel mix thoroughly and also each
time before refuelling.
Starting a cold engine
Starting a warm engine
Per ANSI B175.3
Sound pressure level
76.8
dB(A)
The following signal words and meanings are intended to
explain the levels of risk associated with this product.
DANGER
Indicates an imminently hazardous situation, which, if
not avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
CAUTION
Without safety alert symbol
Indicates a situation that may result in property damage.

SYMBOLS IN THIS MANUAL

Parts or accessories sold separately
Note
Warning
Risk of fire
Do not smoke
Lock
4
Unlock
ASSEMBLY
UNPACKING
The product requires assembly.
■ Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
WARNING
If any parts are damaged or missing, do not operate the
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING
Never attach or adjust any attachment while power head
is running. Failure to stop the engine may cause serious
personal injury.
WARNING
To avoid serious injury, ensure that all grass deflector
and covers are correctly fitted and all fixings and
fasteners are tight before use. Re-check tightness after
a period of use.

ATTACHING THE FRONT HANDLE

■ Remove the bolt and wing nut from the front handle.
■ Install the front handle onto the top side of the drive
shaft in the area indicated by the label.
■ Place the bolt through the front handle.
NOTE: The hex bolt head fits inside the hex recess
molded into one side of the handle.
■ Reinstall the wing nut.
■ Tighten wing nut securely.
ATTACHING THE CURVED SHAFT GRASS DEFLECTOR
■ Remove the bolt and wing nut from grass deflector.
■ Press the grass deflector onto the bottom of the curved
shaft.