Omron CJ2H-CPU6-EIP Connection Manual page 21

7. Connection Procedure
4
The Transfer from PLC Dialog
Box is displayed. Select the I/O
Table Check Box and the SIO
Unit Parameters Check Box,
and click the Transfer Button.
The Transfer from PLC Dialog
Box is displayed.
Confirm that the transfer was
normally executed by checking
the message in the dialog box.
When the I/O table is created
normally, the dialog box shows
the following:
Transfer Success: 1 Unit
Transfer Unsuccessful: 0 Unit
Click the OK Button.
Precautions for Correct Use
Confirm that the Ethernet cable is connected before proceeding to the following procedure.
If it is not connected, turn OFF the power supply to each device, and then connect the
Ethernet cable.
18