Table of Contents
Advertisement
6.6.5
Landing arrays onto a dolly
Landing the array elements directly onto a dolly makes transportation easier.
Notice!
Dolly stacking limits
X12T-DOLLY accommodates two (2) columns of X1 or X2 loudspeaker systems stacked three
(3) high for transportation. The dolly is designed for a total of six (6) loudspeakers per dolly.
X12-128-DOLLY accommodates one (2) column of X12-128 subwoofers stacked two (2) high
for transportation. The dolly is designed for a total of two (2) subwoofers per dolly.
Notice!
Dolly Wheel (the 4º hole):
The bottom element to be landed on the dolly base must be pinned in 4° hole ( ) in the
ANGLE SELECT section. Compress the rear link bars until they contact the angle select pin
and lock by adding a second pin in the EVEN holes of the ANGLE LOCK section.
Ensure the two (2) front link bars are lowered and locked.
To land an array onto a dolly, do the following:
1.
2.
3.
Electro-Voice
Lower the array (A) to a convenient working height above the floor.
If single pin compression method was used, carefully reverse the hoist and uncompress
the back of the array so the hoist has not tension and all of the elements in the array have
returned to the 0° position.
OR
If double pin method was used, lift up slightly on the rear of each of the bottom three (3)
elements and remove the quick-release pins from the lock holes. Gravity will cause the
unlocked rigging splay to revert to 0° position.
Disengage the eight (8) dolly pins (B) on the dolly base.
All eight (8) dolly pins are disengaged and hanging from the dolly.
Installation Manual
en
45
2015.04 | 02 | F.01U.310.953
Hide quick links:
Advertisement
Table of Contents
